Arriba

Adafruit LED Lighting Development Tools 8-Channel PWM or Ser

Modelo 1ABIL72K
Fabricante o sello Adafruit
Peso 0.05 Kg.
Precio:   $70,289.00
Si compra hoy, este producto se despachara y/o entregara entre el 09-04-2024 y el 17-04-2024
Descripción
-Titulo Original : LED Lighting Development Tools 8-Channel PWM or Servo FeatherWing Add-on For All Feather Boards (1 piece)

-Fabricante :

ADAFRUIT

-Descripcion Original:

There's an I2C-controlled PWM driver with a built in clock. That means that, unlike the TLC5940 family, you do not need to continuously send it signal tying up your microcontroller, its completely free running! // It is 5V compliant, which means you can control it from a 3.3V Feather and still safely drive up to 6V outputs (this is good for when you want to control white or blue LEDs with 3.4+ forward voltages) // 6 address select pins so you can stack up to 62 of these on a single i2c bus, a total of 992 outputs - that's a lot of servos or LEDs // Adjustable frequency PWM up to about 1.6 KHz // 12-bit resolution for each output - for servos, that means about 4us resolution at 60Hz update rate // A Feather board without ambition is a Feather board without FeatherWings! This is the 8-Channel PWM or Servo​ FeatherWing, you can add 8 x 12-bit PWM outputs to your FeatherWing. Using our Feather Stacking Headers or Feather Female Headers you can connect a FeatherWing on top or bottom of your Feather board and let the board take flight! You want to make a cool robot, maybe a hexapod walker, or maybe just a piece of art with a lot of moving parts. Or maybe you want to drive a lot of LEDs with precise PWM output. What now? You could give up OR you could just get our handy PWM and Servo FeatherWing. It's a lot like our popular PWM/Servo Shield but with half the channels & squished into a nice small portable size and works with any of our Feather boards. Since the FeatherWing only uses the I2C (SDA & SCL pins), it works with any and all Feathers- ATmega32u4, ATSAM M0 or ESP8266-based. You can stack it with any other FeatherWing or with itself (just make sure you have each wing with a unique I2C address). This product comes with a fully tested and assembled wing as well as 2 pieces of 3x4 male straight header (for servo/LED plugs), a 2-pin terminal block (for power) and a stick of 0.1 header so you can plug into a Feather. A little light soldering will be required to assemble and customize the board by attaching the desired headers but it is a 15 minute task that even a beginner can do. Technical Details Dimensions: 50.8mm x 22.9mm x 1.6mm / 2 x 0.9 x 0.06 Weight: 3.9g
    Compartir en Facebook Comparta en Twitter Compartir vía E-Mail Share on Google Buzz Compartir en Digg