Arriba

Adafruit Dotstar Digital Led Strip - Black 144 Led/m - 0.5.

Modelo 1BMRUPKE
Fabricante o sello Adafruit
Peso 0.10 Kg.
Precio:   $131,989.00
Si compra hoy, este producto se despachara y/o entregara entre el 09-04-2024 y el 17-04-2024
Descripción
-Titulo Original : Adafruit DotStar Digital LED Strip - Black 144 LED/m - 0.5 Meter - BLACK [ADA2328]

-Fabricante :

ADAFRUIT

-Descripcion Original:

Adafruit Part Number: 2328 // Stock Type: LEDs >> Strips // In Stock & Ready to Ship // Move over NeoPixels, there's a new LED strip in town! These fancy new DotStar LED strips are a great upgrade for people who have loved and used NeoPixel strips for a few years but want something even better. DotStar LEDs use generic 2-wire SPI, so you can push data much faster than with the NeoPixel 800 KHz protocol and there's no specific timing required. They also have much higher PWM refresh rates, so  you can do Persistence-of-Vision (POV) and have less flickering, particularly at low brightness levels.Like NeoPixels, DotStar LEDs are 5050-sized LEDs with an embedded microcontroller  inside the LED . You can set the color/brightness of each LED to 24-bit color (8 bits each red green and blue). Each LED acts like a shift register, reading incoming color data on the input pins, and then shifting the previous color data out on the output pin. By sending a long string of data, you can control an infinite number of LEDs, just tack on more or cut off unwanted LEDs at the end. The PWM is built into each LED-chip so once you set the color you can stop talking to the strip and it will continue to PWM all the LEDs for youHowever, unlike NeoPixels, these LEDs have 2 wires (input and output) for sending data - one clock pin and one data pin. That means you need two pins, not one, to control DotStars.  Because the clock and data is seperated, you can use any processor speed or type to control these strips, and you don't have to worry about being careful with the timing . Hardware SPI support is handy but not required. This makes them excellent for use with any microcontroller or microprocessor, including Arduino, Raspberry Pi, BeagleBone, Propeller, SparkCore, and any 'raw' microcontrollers/microprocessors. It's very easy to port the library, and you can send data to the pixels at up to 32MHz clock rate!Another nice thing about DotStars is their high PWM rate. You only have to set the 24-bit
    Compartir en Facebook Comparta en Twitter Compartir vía E-Mail Share on Google Buzz Compartir en Digg